AudioCodes Media Pack MP-11x, Руководство пользователя

Страница: 496 / 650

User's Manual 496 Document #: LTRT-65432
MP-11x & MP-124
Parameter Description
communication error.
Notes:

For this parameter to take effect, a device reset is required.

Enable LAN watchdog is relevant only if the Ethernet connection
is full duplex.

LAN watchdog is not applicable to MP-118.
[LifeLineType] Defines the condition(s) upon which the Lifeline analog (FXS)
feature is activated. The Lifeline feature can be activated upon a
power outage, physical disconnection of the LAN cable, or network
failure (i.e., loss of IP connectivity). Upon any of these conditions,
the Lifeline feature provides PSTN connectivity and thus call
continuity for the FXS phone users.
If the device is in Lifeline mode and the scenario that caused it to
enter Lifeline (e.g., power outage) no longer exists (e.g., power
returns), the device exists Lifeline and operates as normal.

[0] = (Default) Lifeline is activated upon power outage.

[1] = Lifeline is activated upon power outage or when the link is
down (i.e., physically disconnected).

[2] = Lifeline is activated upon a power outage, when the link is
down (physically disconnected), network failure (logical link
disconnection), or when the Trunk Group is in Busy Out state
(see the EnableBusyOut parameter).
The Lifeline (FXS) phone is connected to the following port:

MP-11x FXS-only device: FXS Port 1

MP-118 FXS/FXO device: FXS Ports 1 to 4
For the FXS-only device, FXS Port 1 connects to the POTS
(Lifeline) phone as well as to the PSTN / PBX, using a splitter
cable. For the combined FXS / FXO device, the FXS ports are
provided with a lifeline by their corresponding FXO ports which are
connected to the PSTN / PBX (i.e., FXO Port 5 provides a lifeline
for FXS Port 1, FXO Port 6 provides a lifeline for FXS Port 2, and
so on).
Notes:

For this parameter to take effect, a device reset is required.

This parameter is applicable only to FXS interfaces.

For optional value [2], lifeline activation upon an IP network
failure or Busy Out state is not supported by MP-118.

To enable Lifeline upon a network failure, the LAN watch dog
must be activated (i.e., set the parameter EnableLANWatchDog
to 1).

For information on Lifeline cabling, refer to the Installation
Manual.
Web: Delay After Reset [sec]
[GWAppDelayTime]
Defines the time interval (in seconds) that the device's operation is
delayed after a reset.
The valid range is 0 to 45. The default is 7 seconds.
Note: This feature helps overcome connection problems caused by
some LAN routers or IP configuration parameters' modifications by
a DHCP server.
[EnableAutoRAITransmitBER] Enables the device to send a remote alarm indication (RAI) when
the bit error rate (BER) is greater than 0.001.

[0] Disable (default)