Associated Research HYAMP II 5030DT, Руководство по эксплуатации и обслуживанию

Страница: 19 / 53

CONTROLS
15
9. WITHSTAND PROCESSING LED:
The Withstand Processing LED illuminates
when Remote I/O signal input contacts 6 and 7 have been activated. Used to indicate
HV on when interconnected to a hipot tester.
10. KEY LOCKOUT LED:
When the Key Lockout light is ON the "password"
software lockout has been enabled. This means that the operator will be unable to
access the "program" mode of the instrument to change any settings.
11. REMOTE LED:
This LED illuminates when the unit is in remote control mode.
12. LCD DISPLAY: The Liquid Crystal Display is the main readout for the operator
and programmer of the test settings and test result.
13. EXIT KEY: Use this key when you desire to enter the Run Mode to initiate a test
or use this key when you enter numeric data during a Setup routine and you wish to
clear the information.
14. m
Ω
OFFSET KEY: The milliohm offset key is used to offset any unwanted
resitance that should not be included in the actual resistance value to be used for
criteria comparison.
15. DOWN ARROW
Ð :
(FUNCTION KEY) Use this key to advance forward through
the setup menus, remote, volume, and contrast. Also may be used to decrease output
current during a test in 10 mA increments.
16. ENTER KEY: Use the enter key after entering new data through the keypad to save
it. This key also used to toggle ON/OFF functions.
FRONT PANEL CONTROLS