Debug
ARM DDI 0363E
Copyright © 2009 ARM Limited. All rights reserved.
11-40
ID013010
Non-Confidential, Unrestricted Access
11.6.2
Halting debug event
The debugger or the system can cause the processor to enter into debug state by triggering any
of the following halting debug events:
•
assertion of the
EDBGRQ
signal, an External Debug Request
•
write to the DRCR[0] Halt Request control bit.
If
EDBGRQ
is asserted while
DBGEN
is HIGH but invasive debug is not permitted, the
devices asserting this signal must hold it until the processor enters debug state, that is, until
DBGACK
is asserted. Otherwise, the behavior of the processor is Unpredictable. For DRCR[0]
halting debug events, the processor records them internally until it is in a state and mode so that
they can be taken.
11.6.3
Behavior of the processor on debug events
This section describes how the processor behaves on debug events while not in debug state. See
Debug state
on page 11-44 for information on how the processor behaves while in debug state.
When the processor is in Monitor debug-mode, Prefetch Abort and Data Abort vector catch
debug events are ignored. All other software debug events generate a debug exception such as
Data Abort for watchpoints, and Prefetch Abort for anything else.
When debug is disabled, the
BKPT
instruction generates a debug exception, Prefetch Abort. All
other software debug events are ignored.
When
DBGEN
is LOW, debug is disabled regardless of the value of DSCR[15:14].
Table 11-39 shows the behavior of the processor on debug events.
11.6.4
Debug event priority
Breakpoint, instruction address or CID match, vector catch, and halting debug events have the
same priority. If more than one of these events occurs on the same instruction, it is
Unpredictable which event is taken.
Breakpoint, instruction address or CID match, vector catch cancel the instruction that they occur
on, therefore a watchpoint cannot be taken on such an instruction.
11.6.5
Watchpoint debug events
A precise watchpoint exception has similar behavior to a precise data abort exception:
•
the processor sets R14_abt to the address of the instruction to return to plus
0x08
.
•
the processor does not complete the watchpointed instruction.
If the watchpointed access is subject to a precise data abort, then the precise abort takes priority
over the watchpoint because it is a higher priority exception.
Table 11-39 Processor behavior on debug events
DBGEN
DSCR[15:14]
Debug mode
Action on software debug
event
Action on halting
debug event
0
bxx
Debug disabled
Ignore or Prefetch Abort (for
BKPT
)
Ignore
1
b00
None
Ignore or Prefetch Abort (for
BKPT
)
Debug state entry
1
bx1
Halting
Debug state entry
Debug state entry
1
b10
Monitor
Debug exception
Debug state entry