Wireless keypad PU-R
7 strelec’s control
63
The events "Forced disarming" are filtered by PU-R by default, while reading the
event protocol of the wireless expander. Turn filtration option temporarily off in
order to see the events of forced disarming, while reviewing the event protocol.
7.9
Urgent summon - PANIC
An urgent summon is used for an alarm message to be urgently transmitted to the
Monitoring station or generate an audible prompt alarm signal in the case of emer-
gency.
To generate the event "Panic", press the buttons
‹
›
and
‹
›
simultaneously from PU-R.
A panic signal will be recorded in the event protocol of the wireless expander. A
panic signal transmitted by
PU-R
is delivered to the
first local partition 0
of the
wireless expander (network coordinator).
As soon as the wireless expander acknowledges the signal, audible and light indi-
cation will be turned on at PU-R
1
. If there is no communication with the wireless
expander, no indication will be displayed.
Press any button to turn panic audible alarm signal off. To reset panic, execute the
command "Disarm" (the paragraph 7.6, page 61) for the partition where panic has
been occurred.
7.10
Bypass of tampered detectors
The bypass of a security detector should be turned on
2
, if its current status is tam-
pered, however the partition where the detector is located has been armed
3
.
1
A delay depends on the type of PU-R’s power supply and the current interface (see the paragraph 7.1).
2
Manual bypass can be turned on only if the option of manual bypass has been included to the options of the wire-
less expander.
3
An example of such situation is a small opening window pane that cannot be closed and therefore, the partition
where a reed switch “RIG” is located cannot be armed. Meanwhile, a user would like to arm another detectors of
this partition.
Press simultaneously in
the case of emergency
