Wireless keypad PU-R
7 strelec’s control
52
Panic
1 Partition
7
STRELEC’S CONTROL
7.1
General information
PU-R indicates Strelec’s status based on information read from the wireless ex-
pander functioning as a network coordinator.
A period of information reading, depending on a type of a power supply and acti-
vation of an exchange interface, causes delays of displaying information about
Strelec’s status by Pu-R. Delay values
1
are the following:
Interface
of exchange
Power
supply
Delay, sec.
Typical maximum
RS-232
external
0.5
1
battery
2.5
5
wireless
external
5
10
battery
10
15
All the changes in Strelec’s status are displayed
by windows that occur at the screen with mes-
sages about new events.
Fire, security, fault, tamper and etc. messages are
accompanied by light indication, changes in col-
or of screen illumination and audible alarm sig-
nal.
Audible alarm or fault signal will be turned off automatically in 2 min. or if any
button has been pressed.
When the screen button
‹ Info
›
is pressed, de-
tailed information about an event occurred will
be displayed.
Control of Strelec’s status is conducted by pictographs located in the top part of the
screen (see the paragraph 7.2, page 53), as well as means assessable from the menu
"Status" (see the paragraph 7.3, page 54).
1
The values mentioned are referred only to the delay of displaying information about Strelec’s status at the keypad
PU-R
! Triggering delays of relay outputs, outputs of audible and light indication, etc. have significantly less values
in the wireless expander.
Info
OK
13.06 21:10:01 Panic
РРОП 0 PU-R 1
1 Study room
Back
OK
