Arctic Cat ATV 250 Utility 2009, Руководство по обслуживанию

Страница: 18 / 129

2-10
ADJUSTING SHIFT LEVER
1. Place the shift lever in the N (neutral) position;
then set the engine stop switch to the STOP posi-
tion and turn the ignition switch to the RUN posi-
tion. The neutral indicator light should illuminate.
„
NOTE: If the neutral indicator light does not illu-
minate, adjustment of the shift linkage will be
required. To adjust, proceed to step 2.
2. Loosen the jam nuts on both ends of the shift rod
and turn the shift rod until the neutral light illumi-
nates. Tighten the jam nuts securely.
KM313
„
NOTE: On the DVX 300, the neutral position in the
transmission is indexed by passing a Phillips
screwdriver through the transmission shift arm
and into the index hole in the transmission cover.
KM179A
Hydraulic Brake
Systems
CHECKING/BLEEDING
The hydraulic brake systems have been filled and bled
at the factory. To check and/or bleed a hydraulic brake
system, use the following procedure.
1. With the master cylinder in a level position, check
the fluid level in the reservoir. If the level in the
reservoir is not visible in the sight glass, add DOT
4 brake fluid.
KM113
KM137
2. Compress the brake lever/pedal several times to
check for a firm brake. If the brake is not firm, the
system must be bled.
3. To bleed the brake system, use the following pro-
cedure.
A. Remove the cover and fill the reservoir with
DOT 4 Brake Fluid.
B. Install and secure the cover; then slowly com-
press the brake lever several times.
C. Remove the protective cap, install one end of a
clear hose onto one FRONT bleed screw, and
direct the other end into a container; then while
holding slight pressure on the brake lever, open
the bleed screw and watch for air bubbles.
Close the bleed screw before releasing the
brake lever. Repeat this procedure until no air
bubbles are present.
Back to TOC Back to Section TOC
Next Back