Arctic Cat ATV 250 Utility 2009, Руководство по обслуживанию

Страница: 112 / 129

7-7
7
KM557A
9. Install the shock absorber and secure with the
existing hardware. Tighten to 29 ft-lb.
10. Install the axle housing, axle, and brake assembly
(see Section 6).
11. Install the drive chain and sprockets (see Section
6); then adjust the chain to specifications (see Sec-
tion 2).
12. Apply grease to the axle splines; then install the
hubs and hub nuts. Tighten to 72 ft-lb.
KM468
13. Install new cotter pins; then install the hub caps
and rear wheels. Tighten the lug nuts to 32 ft-lb.
KM469
KM464
14. Remove the ATV from the support stand.
Front A-Arms
„
NOTE: Critical torque specifications are located
in Section 1.
REMOVING
1. Secure the ATV on a support stand to elevate the
front wheels; then remove a front wheel.
2. Remove the hub cap; then remove the cotter pin
from the nut.
SP366
3. Remove the nut securing the hub.
4. Remove the cap screws securing the brake caliper;
then remove the caliper and lay aside.
! WARNING
Make sure the ATV is solidly supported on the support
stand to avoid injury.
Back to TOC Back to Section TOC
Next Back