Arctic Cat ATV 250 Utility 2009, Руководство по обслуживанию

Страница: 97 / 129

6-3
6
KM471
6. Remove the brake disc assembly from the axle.
KM472
7. Loosen the drive chain (see Section 2); then slip
the chain off the sprocket and remove the axle
assembly from the right side.
KM476A
8. Remove the cap screw from the rear brake caliper
holder; then remove the snap ring securing the cal-
iper holder to the axle housing.
KM481A
9. Remove the brake caliper holder and aligning col-
lar. Account for the O-ring.
KM483
10. Remove the four cap screws from the rear of the
swing arm assembly; then remove the rear axle
housing from the right side of the swing arm.
11. Remove the snap ring securing the driven sprocket
to the axle; then remove the sprocket.
KM477
CLEANING AND INSPECTING
1. Inspect the sprocket teeth for wear. If they are
worn as shown, replace the engine sprocket, rear
sprocket, and drive chain as a set.
Back to TOC Back to Section TOC
Next Back