Arctic Cat ATV 250 Utility 2009, Руководство по обслуживанию

Страница: 57 / 129

3-34
KM695
3. Apply oil to the secondary driven bevel gear shaft;
then install the bearing into the case.
KM420
4. Install the flat thrust washer and driven bevel gear
on the driven shaft; then using the universal joint
and vise to hold the shaft, install a new nut and
tighten to 72 ft-lb.
KM425
5. Use a center punch to stake the nut to the driven
shaft.
KM426A
6. Install the high drive gear thrust washer on the
countershaft; then install the high drive gear and
secure with a circlip.
KM685A
7. Install the high gear clutch dog and flat washer. At
this point, the countershaft is ready for installation.
KM684
8. Install the low driven gear washer on the drive-
shaft; then install the low driven gear and thrust
washer. Secure with a snap ring.
Back to TOC Back to Section TOC
Next Back