Arctic Cat ATV 250 Utility 2009, Руководство по обслуживанию

Страница: 47 / 129

3-24
KM369
4. Place the fixed drive face into position on the
crankshaft and engage the splines making sure the
splines extend beyond the pulley face hub.
KM263A
5. On the 250 Utility, install the starter ratchet on the
crankshaft making sure to engage the splines; then
secure with the flange nut and tighten to 68 ft-lb.
KM366
KM365
6. Install the centrifugal clutch housing and clutch
collar; then secure with the flange nut and tighten
to 40 ft-lb.
KM253
KM368
7. Install the alignment pins and a new gasket on the
crankcase; then install the V-belt cover and secure
with the cap screws. Tighten securely.
8. On the 250 Utility, install the recoil starter and
secure with the cap screws. Tighten securely.
Right-Side Components
„
NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
„
NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
AT THIS POINT
To service center crankcase components only, pro-
ceed to Removing Right-Side Components.
AT THIS POINT
To service any one specific component, only limited
disassembly of components may be necessary. Note
the AT THIS POINT information in each sub-section.
Back to TOC Back to Section TOC
Next Back