2-6
.
KM140B
3. Install the spark arrester and secure with the cap
screw. Tighten securely.
Engine Oil - Filter
Replace the engine oil and clean the screen/filter at the
scheduled intervals. The engine should always be
warm when the oil is changed so the oil will drain eas-
ily and completely.
1. Park the ATV on level ground.
2. Loosen the oil fill plug.
KM126A
3. Remove the screen/filter cap from the bottom of
the engine and drain the oil into a drain pan.
Account for a spring, O-ring, and screen/filter.
DSC02248
4. Clean the screen/filter in parts-cleaning solvent;
then inspect the O-ring and replace if damaged.
5. Install the screen/filter, spring, and screen/filter
cap into the bottom of the engine and tighten to 11
ft-lb.
6. Remove the oil fill plug and pour in 1.6 L (1.7
U.S. qt) of the recommended oil into the fill hole;
then install the oil fill plug.
7. Start the engine (while the ATV is outside on level
ground) and allow it to idle for a few minutes.
8. Turn the engine off and wait approximately one
minute. Check the oil level in the engine oil
inspection window. The oil level should be visible
through the window. If oil is not visible, add rec-
ommended oil until the oil level is visible between
the lines of the window.
KM127A
9. Inspect the area around the screen/filter cap for
leaks.
Rear Drive Lubricant
(250 Utility)
Check and change the lubricant according to the Peri-
odic Maintenance Chart. When changing the lubricant,
use approved SAE 80W-90 hypoid gear lube. To check
lubricant, use the following procedure.
1. Remove the rear drive level plug; the lubricant
level should be at the threads of the plug.
! CAUTION
Any oil used in place of the recommended oil could
cause serious engine damage. Do not use oils which
contain graphite or molybdenum additives. These oils
can adversely affect clutch operation. Also, not recom-
mended are racing, vegetable, non-detergent, and cas-
tor-based oils.
Back to TOC
Back to Section TOC
Next
Back
Содержание ATV 250 Utility 2009
Страница 1: ......
