Arctic Cat ATV 250 Utility 2009, Руководство по обслуживанию

Страница: 60 / 129

3-37
3
KM767
„
NOTE: Make sure the crankshaft and rotor/fly-
wheel contact surfaces are clean and dry before
installing the flywheel.
5. Install the key in the crankshaft; then with the
starter one-way bearing correctly installed, place
the rotor/flywheel onto the crankshaft and position
the aligning keyway with the key.
6. Secure the rotor/flywheel on the crankshaft with
the nut and tighten to 47 ft-lb; then install the
spring and oil-through in the crankshaft.
KM773A
7. Install the trigger coil and stator coil in the
right-side crankcase cover; then secure with the
existing hardware and tighten securely.
E. Water Pump
F. Transmission
See Servicing Right-Side Components in this sub-sec-
tion.
Center Crankcase
Components
„
NOTE: This procedure cannot be done with the
engine/transmission in the frame. Complete
Removing procedures for Top-Side, Left-Side, and
Right-Side must precede this procedure.
„
NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
Separating Crankcase
Halves
1. Remove the left-side and right-side cap screws
securing the crankcase halves noting the position
of the different-sized cap screws for joining pur-
poses.
KM720A
2. Using Crankcase Separator/Crankshaft Remover
and tapping lightly with a rubber mallet, separate
the crankcase halves. Account for two alignment
pins and a gasket.
Disassembling
Crankcase Half
1. Remove the crankshaft from the left crankcase
half.
AT THIS POINT
To install the water pump, see Section 4.
Back to TOC Back to Section TOC
Next Back