Arctic Cat ATV 250 Utility 2009, Руководство по обслуживанию

Страница: 45 / 129

3-22
KM380B
KM382A
4. Inspect the pins and bushings for wear, flat spots,
looseness, or cracking.
KM379
5. Measure the driven face spring free length. If the
free length is less than 131 mm, the spring must be
replaced.
KM376
6. Measure the driven fixed face hub using a calipers.
The minimum service limit is 39.93 mm.
KM378
7. Measure the thickness of the centrifugal clutch
shoe lining. The minimum service limit for the lin-
ing is 0.5 mm.
„
NOTE: If any shoe lining is below the service
limit, the complete set must be replaced.
Assembling
1. Place the fixed face of the driven pulley on the
pulley compressor base.
„
NOTE: Make sure the spacer is on the base or
damage to the fixed face will occur when the
spring is compressed.
KX571
2. Apply multi-purpose grease to the O-rings and
grease seals on the movable face; then install on
the fixed face making sure the alignment marks
are properly aligned.
KM374A
Back to TOC Back to Section TOC
Next Back