Arctic Cat ATV 250 Utility 2009, Руководство по обслуживанию

Страница: 52 / 129

3-29
3
KM692A
13. To disassemble the secondary driven bevel gear
assembly, use the following procedure.
A. Secure the universal joint using a suitable vise;
then engage the output end of the shaft with the
universal joint.
KM653
B. Remove the nut securing the driven bevel gear;
then remove the gear. Account for a washer.
KM654
C. Remove the shaft and housing from the univer-
sal joint and remove the shaft from the housing.
„
NOTE: If left-side components are still attached,
remove the centrifugal clutch/driven pulley (see
Removing Left-Side Components in this section).
B. Water Pump
C. Trigger Coil
D. Stator Coil
E. Rotor/Flywheel
14. Remove the right crankcase cover (see Section 4 -
Water Pump).
15. Remove the trigger coil mounting screws; then
remove the wire set plate.
KM772A
16. Remove the three cap screws securing the stator
coil to the crankcase cover; then remove the stator
coil and trigger coil.
17. Remove the oil-through and spring from the end of
the crankshaft; then hold the rotor/flywheel with
an appropriate holding tool and remove the fly-
wheel nut and washer.
KM774
18. Install the flywheel puller and crankshaft protec-
tor; then remove the rotor/flywheel. Account for a
key and the starter one-way clutch bearing.
AT THIS POINT
To remove/service the water pump, see section 4.
! CAUTION
Use extreme care to avoid damaging or shorting the
wiring.
Back to TOC Back to Section TOC
Next Back