CNC Setup Utility Manual
P/N 70000490C - Machine Constants
2-56
All rights reserved. Subject to change without notice.
10-December-04
Table 2-2, Machine Constants Setup
(Continued)
Machine Constant
Parameter
Function Settings
MC_4051:
Y Jog position
Y jog position defines a point on the
machine Y-axis in reference to Machine
Home to which the CNC will return
when the Jog and Return function is
activated.
Range (-9999.0000–25400.0000)
0.0000 [Default]
MC_4052:
Z Jog position
Z jog position defines a point on the
machine Z-axis in reference to Machine
Home to which the CNC will return
when the Jog and Return function is
activated.
Range (-9999.0000–25400.0000)
0.0000 [Default]
MC_4053:
U Jog position
U jog position defines a point on the
machine U-axis in reference to Machine
Home to which the CNC will return
when the Jog and Return function is
activated.
Range (-9999.0000–25400.0000)
0.0000 [Default]
Direct Numeric Control (DNC) Setup Parameters
MC_4060:
DNC Execution Mode
Buffered
[Default]
Drip Feed
MC_4061:
DNC Buffer Size (in
buff. mode)
32K
[Default]
64K
128K
Max
MC_4062:
DNC Use DNC Macro
at end of block
Select to use a specified DNC Macro at
the end of each block.
No
(disabled) [Default]
Yes (enabled)
MC_4063:
DNC Macro Number
Enter the DNC Macro Number to use at
the end of each block.
Range (100–32000)
100 [Default]
MC_4064
DNC Ignore G41/2,
G59, and Blueprint
The operator can enable/disable
processing for G41 (left of path), G42
(right of path), G59 (Corner Rounding),
and Blueprint programming (Canned
Cycles). While in DNC, these features
should be disabled unless absolutely
required. If these features are enabled,
even if a program does not use them,
the CNC will waste processing time.
Yes
[Default]
No
Choose
Yes
to disable Tool Comp
and CornerRad. Choose
No
to
enable Tool Comp and CornerRad
during DNC.
MC_4065:
DNC Wait for Start
No
First
[Default]
Every
(Continued…)
