CNC Setup Utility Manual
P/N 70000490C - Machine Constants
2-78
All rights reserved. Subject to change without notice.
10-December-04
MC_2966: High setting for M42 gear range
[Default:
501
rpm]
MC_2967: Low setting for M43 gear range
[Default:
500
rpm]
MC_2968: High setting for M43 gear range
[Default:
0
rpm]
MC_2969: Low setting for M44 gear range
[Default:
1,470
rpm]
MC_2970: High setting for M44 gear range
[Default:
4,640
rpm]
Ballscrew Compensation Parameters
The Ballscrew Compensation Parameter Group ranges from MC_3050
through MC_3099.
Automatic File Loader
Reference machine constant parameter:
MC_3072: Edit Ballscrew Table
.
This feature automatically loads a properly formatted laser data file into
the Table Entries Setup Menu.
NOTE:
The File Loader does not change the way segment length
ballscrew compensation is set. However, you must enter
additional information. Some editing of the laser file will be
necessary.
To load the laser file:
Select
On
. Press
Ldfile
(
F8
). Enter the appropriate password, if required
by the system.
The CNC displays the Leadscrew Compensation File Loader menu. See
Figure 2-2, Ballscrew Compensation Loader Menu
Table 2-4, Ballscrew File Loader Parameters
for a description of the
Ballscrew File Loader Parameters.
Highlight
Starting Segment
. Type the segment number of the first table
entry, and press
ENTER
.
Highlight
Ending Segment
. Type the segment number for the last table
entry, and press
ENTER
.
Highlight
Axis
, and press
ENTER
.
The CNC displays a pop-up menu with the following choices:
X
or
Z
.
5. Highlight the desired axis, and press
ENTER
.
The CNC returns to the Leadscrew Compensation File Loader menu.
6. Highlight
Action
, and press
ENTER
.
7. Highlight an option in the pop-up menu, and press
ENTER
.
8. Press
Ldfile
(
F8
) again to load the file.
