Programming
116
MVP-5200i Modero® ViewPoint® Touch Panel with Intercom - Instruction Manual
Dynamic Image Commands
The following table describes Dynamic Image Commands.
Dynamic Image Commands
^BBR
Set the bitmap of a button to use a particular resource.
Syntax:
"'^BBR-<vt addr range>,<button states range>,<resource name>'"
Variable:
variable text address range = 1 - 4000.
button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons 1 = Off state and 2 = On state).
resource name = 1 - 50 ASCII characters.
Example:
SEND_COMMAND Panel,"'^BBR-700,1,Sports_Image'"
Sets the resource name of the button to ’Sports_Image’.
^RAF
Add new resources - Adds any and all resource parameters by sending embedded codes and data. Since the embedded codes
are preceded by a '%' character, any '%' character contained in the URL must be escaped with a second '%' character (see
example).
The file name field (indicated by a
%F
embedded code) may contain special escape sequences as shown in the
^RAF, ^RMF -
Embedded Codes
table below.
Syntax:
"'^RAF-<resource name>,<data>'"
Variables:
• resource name = 1 - 50 ASCII characters.
• data = Refers to the embedded codes, see the
^RAF, ^RMF - Embedded Codes
section on page 117.
Example:
SEND_COMMAND Panel,"'^RAF-New Image,%P0%HAMX.COM%ALab/Test%%5Ffile%Ftest.jpg'"
Adds a new resource.
The resource name is ’New Image’
%P (protocol) is an HTTP
%H (host name) is
AMX.COM
%A (file path) is
Lab/Test_file
%F (file name) is
test.jpg
.
Note that the
%%5F
in the file path is actually encoded as
%5F
.
^RFR
Force a refresh for a given resource.
Syntax:
"'^RFR-<resource name>'"
Variable:
resource name = 1 - 50 ASCII characters.
Example:
SEND_COMMAND Panel,"'^RFR-Sports_Image'"
Forces a refresh on ’Sports_Image’.
^RMF
Modify an existing resource - Modifies any and all resource parameters by sending embedded codes and data. Since the
embedded codes are preceded by a '%' character, any '%' character contained in the URL must be escaped with a second '%'
character (see example).
The file name field (indicated by a
%F
embedded code) may contain special escape sequences as shown in the
^RAF, ^RMF -
Embedded Codes
section on page 117.
Syntax:
"'^RMF-<resource name>,<data>'"
Variables:
• resource name = 1 - 50 ASCII characters
• data = Refers to the embedded codes, see the
^RAF, ^RMF - Embedded Codes
section on page 117.
Example:
SEND_COMMAND Panel,"'^RMF-Sports_Image,%ALab%%5FTest/Images%Ftest.jpg'"
Changes the resource ’Sports_Image’ file name to ’test.jpg’ and the path to ’Lab_Test/Images’.
Note that the
%%5F
in the file path is actually encoded as
%5F
.
^RSR
Change the refresh rate for a given resource.
Syntax:
"'^RSR-<resource name>,<refresh rate>'"
Variable:
resource name = 1 - 50 ASCII characters.
refresh rate = Measured in seconds.
Example:
SEND_COMMAND Panel,"'^RSR-Sports_Image,5'"
Sets the refresh rate to 5 seconds for the given resource (’Sports_Image’).
