Ametek EC1000S, Руководство пользователя, Страница: 246 / 291

User Manual EC1000S
California Instruments 242
6.6 Error Message List
USB error messages are listed in Table 6-15 below.
Table 6-15. USB Error Message List
No. Message Cause
0
“No error”
No error.

100
“Command error”
Command was recognized as invalid due to any cause.
(General command error)

101
“Invalid character”
Command was recognized as invalid due to invalid
characters (such as “VOLT&”) in command string.

102
“Syntax error”
Command was recognized as invalid due to reception of
undefined command or parameter.

200
“Execution error”
Error occurred when executing the command due to any
cause. (General execution error)

222
“Data out of range”
Error occurred when executing the command due to out of
range parameter.

350
“Too Many Errors”
New errors cannot be retained due to error queue overflow.
1
“Invalid with output on”
Error occurred when executing the command because the
output relay was on.
2
“Invalid with output off”
Error occurred when executing the command because the
output relay was off.
3
“Invalid in this mode”
Error occurred when executing the command due to
inappropriate output mode.
4
“Under Busy State”
Error occurred during execution of command due to busy
device.
5
“Out of Limiter”
Error occurred during execution of command because
limiter value was exceeded.
6
“Invalid in this frequency”
Error occurred when executing the command due to
inappropriate oscillation frequency setting.
7
“Out of Input Signal
frequency”
Error occurred when executing the command due to out of
the external synchronization frequency range.
8
“Under Warning State”
Error occurred when executing the command because
device was operating in protected mode.