Ametek EC1000S, Руководство пользователя

Страница: 212 / 291

User Manual EC1000S
California Instruments 208
Parameters: None
Query example: SEQ:LEN?
Response format: <NR1>
Response example: 255

[SOURce:]SEQuence:COUNt?
This returns the jump times of the step specified by SEQ:STEP. The step jump times response
ranges from

1 to 999.

1 is returned in the idle mode.
Syntax: [SOURce:]SEQuence:COUNt?
Parameters: None
Query example: SEQ:COUN?
Response format: <NR1>
Response example: 2

[SOURce:]SEQuence:DELete
This clears the sequence memory. When this command is executed, all sequence step settings
are cleared.
However, the sequence memory contains a separate sequence for each operation mode (AC
and AC+DC) and each output voltage range (100 V and 200 V), for a total of four combined sets.
When sequence memory is cleared by this command, only one of these four sets is selected as
the memory.
When in AC-EXT, AC-SYNC, AC+DC-EXT, or AC+DC-SYNC mode, sequence memory cannot
be cleared. ([3,
“Invalid in this mode”] error occurs.)
Syntax: [SOURce:]SEQuence:DELete <NR1>
Parameters: 1
Command example: SEQ:DEL 1
Response format: None
Response example: None

[SOURce:]SEQuence:EPARameter
This sets the step execution parameters.
The target sequence step must be already set by the SEQ:STEP. ( See
“ 
[SOURce:]SEQuence:STEP
” on page 212.)
However, the first parameter (DC voltage) and second parameter (DC voltage operation type)
are valid only during AC+DC mode. When in AC mode, dummy values should be set.
A “0” is
returned for each of these parameters when in AC mode.
The unit of the third parameter varies depending on the waveform set by the seventh parameter.