Ametek EC1000S, Руководство пользователя

Страница: 108 / 291

User Manual EC1000S
California Instruments 104
Table 4-6. Sequence Modes
Idle mode Mode during normal output.
Run mode Mode during sequence execution.
Hold mode
Sequence pause mode.
Maintains output at time when <Hold> was set.

d) Sequence control
The following describes how sequence operations are controlled. Sequence control operations are
indicated in triangular brackets (< >).
Table 4-7. Sequence Control
<Start>
Sets Run mode.
When changing from Idle mode, the operation goes to step 1 when <Start>
is set, and the sequence is started.
When changing from Hold mode, the sequence is resumed from where it
was stopped when <Hold> was set.
When <Hold> mode is set by the [step end] parameter, the sequence is
resumed at the step specified by [jump step] when <Start> is set.
<Hold> Changes from Run mode to Hold mode.
<Stop>
Changes to Idle mode.
Immediately changes to normal output step.
At that time, the values when <Stop> occurred are retained to the normal
output step [output parameter].
If the voltage or frequency setting when the <Stop> occur exceeds the
setting range limit, it is set to the lower limit value of the setting range limit.
<Branch>
Changes to the step specified by [branch step].
Changes from the output at the time when <Branch> occurred to the [branch
step].
<Hold>
<Start>
Step 2 settings
• Final value
• Step time
Step 1 Step 2 Time Step 3
Output parameter
Figure 4-7. Example of Sequence Operation from Hold Mode to <Start>