Alpha-InnoTec HT 12Split, Инструкция по установке и эксплуатации

Страница: 47 / 80

47
HT 6Split
HT 12Split
Chapter 9 |
Control
ADVICE
If you wish to set similar scheduling for every day of
the week start by filling in “all” and then changing the
desired days.
CAUTION
If comfort mode "luxury" is selected in menu 2.2 no
further increase can be carried out.
Menu 2.2 - Comfort mode
The function is activated immediately once a time peri-
od is selected and confirmed using the OK button. The
remaining time for the selected setting is shown to the
right. When the time has run out, the controller returns
to the mode set in menu 2.2.
Please select “off” to switch off temporary lux. mode.
In this menu, you can select the operating modes for
various hot water temperatures. For more information
select "?".
Factory setting: normal
Smart control - In this menu, you can activate the
Smart Control function. The function learns the pre-
vious week’s hot water consumption and adapts the
temperature in the water heater for the coming week
to ensure minimal energy consumption.
If the hot water demand is greater, there is a certain
additional amount of hot water available.
When the Smart Control function is activated, the wa-
ter heater delivers the performance reported on the
energy label.
Economy - provides a smaller amount of hot water, but
is more economical. This mode can be used in smaller
households with a small hot water demand.
Normal - Normal mode provides a larger amount of
hot water and is suitable for most households.
Luxury - Luxury mode provides the greatest possible
amount of hot water. In this mode, the additional
Menu 2.3 - Scheduling
Two different periods of hot water temperature per
day can be scheduled here. Scheduling is activated/
deactivated by ticking/unticking “on”. Set times are
not affected at deactivation. For more information se
-
lect "?".
Factory setting: off
Schedule: The schedule to be changed is selected
here.
Activated: Scheduling for the selected period is acti-
vated here. Set times are not affected at deactivation.
Day: Select which day or days of the week the sched-
uling is to apply to here. To remove the scheduling for
a particular day, the time for that day must be reset
by setting the start time to be the same as the finish
time. If the line “all” is used, all days in the period are
set for these times.
Time period:
The scheduled start and finish time for
the selected day are selected here.
Adjustment: Set the hot water temperature that is to
apply during scheduling here.
Conflict:
If two settings conflict with each other, a red
exclamation mark is displayed.
heat, as well as the compressor, may be used to heat
hot water, which may increase operating costs.
Factory settings: off
SCHEDULING HEATING 1
.
3
.
1
activated
schedule
2
system
schedule
3
schedule
1
all
mon
tues
wed
thur
fri
sat
sun
21 : 30 - 06 : 00
20
.
5
°
T ime period A djusting D ay
A ctivated S chedule S ystem
C onflict