Alpha-InnoTec HT 12Split, Инструкция по установке и эксплуатации

Страница: 43 / 80

43
HT 6Split
HT 12Split
Chapter 9 |
Control
Settings for the user
CAUTION
Recommended operating mode “auto”. This may only
be edited by qualified persons.
In this menu, you can choose the operating mode for
the HT 6Split / HT 12Split unit. For more information
select "?".
Factory settings: auto
In this menu, you can activate alarm actions. For more
information select "?".
Factory settings:
Reduce room temp.: deactivated
Stop hot water: deactivated
Reminder to fill in the checklist in section 1 of the User
manual.
In this menu, you can choose whether the start guide
will restart the next time the system is started up.
13/16 Operating mode
14/16 Alarm actions
15/16 Reminder
16/16 Start guide
Menu 1 – Indoor climate
Menu 1.1 – Temperature
The INDOOR CLIMATE menu is used to modulate
the settings for the climate system. There are several
submenus. Status information for the relevant menu
can be found on the display to the right of the menus.
In this menu, you can set the temperature for the cli-
mate system. The status information shows the set
point values for the climate system.
In Menu 1.1 choose between heating or cooling (if
active) and then set the desired temperature in the
next menu “Heating/cooling temperature”.
The display shows the set point values for the sys-
tem (offset heating curve). To increase or reduce the
indoor temperature, increase or reduce the value on
the display.
For more information select "?".
Setting the temperature (without room sensors acti-
vated):
Setting range: -10 do +10
Factory setting: 0