Alpha-InnoTec HT 12Split, Инструкция по установке и эксплуатации

Страница: 34 / 80

34
HT 6Split
HT 12Split
A
B
C
D
E
F
Display
Status lamp
OK bu�on
Back bu�on
Control knob
Switch
G
USB port
8 Control - Introduction
Display unit
Instructions, settings and operational information
are shown on the display. You can easily navi-
gate between the different menus and options
to set the comfort or obtain the information you
require.
The USB port is hidden beneath the plastic
badge with the product name on it.
The USB port is used to update the software.
The switch assumes three positions:
• On ( I )
• Standby ( )
• Emergency mode ( )
Emergency mode must only be used in the event
of a fault on the control module. In this mode,
the compressor in the heat pump switches off
and the immersion heater engages. The control
module display is not illuminated and the status
lamp illuminates yellow.
The status lamp indicates the status of the con-
trol module. It:
• lights green during normal operation.
• lights yellow in emergency mode.
• lights red in the event of a deployed alarm.
The OK button is used to:
•
confirm selections of sub menus/options/set
values/page in the start guide.
The back button is used to:
• go back to the previous menu.
• change a setting that has not been con-
firmed.
The control knob can be turned to the right or
left. You can:
• scroll in menus and between options.
• increase and decrease the values.
• change page in multiple page instructions
(for example help text and service info).
Display
USB port
Switch (SF1)
Status lamp
OK button
Back button
Control knob
A
G
F
B
C
D
E
Chapter 8 |
| Control - Introduction