Airspan AS3010, Руководство по вводу в эксплуатацию

Страница: 233 / 580

C o m m i ssion ing M anu al E st ab l i sh i n g B S R - S P R L i n k w i t h Au t o C o n n ect
8.3. Configuring AutoConnect with Redirection
You can configure an SPR to undergo AutoConnect only once. The SPR initially
(i.e. after reset or powered on) connects to a BSR with which it has the strongest RF
signal, but then disconnects and reconnects (i.e. redirected) to a specific BSR,
selected by the user. Even if the SPR is later reset or powered off and then on again,
the SPR always connects to the specific BSR (i.e. does not undergo AutoConnect).
The following subsections describe the procedures for configuring AutoConnect
with Redirection for SPR devices.
Notes:
1) If WipManage fails to redirect the SPR to the redirected BSR (due to some
problem), SPR remains connected to the BSR with which it connected initially
though AutoConnect.
2) SPR redirection can occur to the same BSR with which the SPR initially
connects through AutoConnect. In such a scenario, the SPR associates with
the same BSR, but with a different index number.
3) For redirection, all BSRs in the network must have the same Management
VLAN ID, Air Subnet, Managers Table, and Get/Set Community settings.
01040311-07 Airspan Networks Inc. 8-27