Agilent Technologies 34970A, Руководство пользователя, Страница: 211 / 356

211
Chapter 4 Features and Functions
34907A Multifunction Module
4
34907A Multifunction Module
This module combines two 8-bit ports of digital input/output, a 100 kHz
totalizer, and two ±12V analog outputs. For greater flexibility, you can
read digital inputs and the totalizer count during a scan.
Digital Input/Output
The DIO consists of two 8-bit ports with TTL-
compatible inputs and output. The open-drain
outputs can sink up to 400 mA. From the front
panel, you can read data from only one 8-bit
input port at a time. From the remote interface,
you can read both ports simultaneously as a 16-
bit word
only if neither port is in the scan list.
Totalize Input
The 26-bit totalizer can count pulses at a 100 kHz
rate. You can configure the totalizer to count on
the rising edge or falling edge of the input signal.
A TTL high signal applied to the “
G
” terminal
enables counting and a low signal disables
counting. A TTL low signal applied to the “ ”
terminal enables counting and a high signal
disables counting. The totalizer only counts when
both terminals are enabled. Move the
Totalize
Threshold jumper to the “AC” position to detect
changes through 0 volts. Move the jumper to the
“TTL” position (factory setting) to detect changes
through TTL threshold levels.
Analog Output (DAC)
The two analog outputs are capable of outputting
calibrated voltages between ±12 volts with 16
bits of resolution. Each DAC channel is capable of
10 mA maximum current. You must limit the
DAC output current to 40 mA total for all three
slots (six DAC channels).
Port 1 (LSB)
Channel 01
Port 2 (MSB)
Channel 02
8
8
DIO
Bit 7
Bit 0
Bit 7
Bit 0
Channel 03
26 Bits
Gate
Gate
-IN
+IN
TOT
DAC 1
DAC 2
16
16
Channel 04
Channel 05
G
34970A Refresh UG.book Page 211 Wednesday, February 17, 2010 12:34 PM