73
5. Mark
“Cowl Side”
on the top side of the tem-
plate. It is very important that the template does
not change position when attached to the cowl.
6. Trace around mufflers being careful to keep the
template in the same location.
Note:
Because the Carbon Cub uses a 2 piece
cowling, the muffler holes will not need to be
elongated. By separating the top and bottom
cowl pieces the bottom cowl can be slid over
the muffler stacks.
7. Use a hobby knife to cut out the muffler exit as
shown.
8. Check the fit of the template at this time. It may
be necessary to make small adjustments to the
cutout to get it to fit properly.
9.
Align template to cowl using the air scoop as a
guide. Once the template is in the correct posi-
tion use masking tape to secure it to the cowl.