38
2. Slide the carbon stab tubes into the stab and then
slide the tubes through the slot in the fuse as
shown.
4. Use a drop of thick CA glue on each screw to
prevent screws from loosening due to vibration
as shown.
Note:
CA glues have a fast drying time.
Remember to work quickly.
5. Align the left and right sides of the control horns
to the mounting holes and mount using six
T2.6x15mm wood screws.
6. Attach servo arm to servo as shown below.
Note:
On metal geared servos use Loctite for all
Servo arm mounting screws.
Builders Tip:
If using Hitec Servos, replace Phillips
head servo arm screw with a socket head screw. This
will allow for easier removal at a later date. These
screws can be purchased from Micro Fasteners and
are part number: SCM2508
1. Gather the stab mounting parts as shown below.
Required Parts
◊
1 - 8mm x 202mm Front Stab Tube
◊
1 - 8mm x 305mm Rear Stab Tube
◊
4 - 8-32 x 15mm Bolts
◊
4 - 8-32 Flat Washers
◊
4 - 8-32 Split ring lock washers
Required Tools and Adhesives
◊
1 - 7/64” Ball Driver
◊
1 - .34oz Bottle Blue IC-Loc Thread Locker
Stabilizer Installation
