40
Option 3: -1
˚ Stab incidence-
Not Recommended
1. 1 degree of negative incidence can be achieved
by removing the plywood spacer at the bottom
of the mounting slot. This stab position is not
recommended but can be accomplished by the
removal of this spacer. This will lower the tail of
the plane in flight.
2. In order to remove the plywood spacer, trim the
covering at the bottom of the stab mount as
shown.
3. The plywood spacer has been placed in the fuse
and may need to be trimmed slightly for re-
moval.
4. Once the spacer has been cut from the fuse, it
can be removed.
5. Once the desired position has been located, se-
curely tighten the mounting bolts.
Note:
Set the stab incidence to zero for general
flying. This can be achieved by setting the
front L bracket on the top of the pre-installed
plywood spacer and tightening the mounting
bolts as shown. If spacer has been removed
an incidence meter may be used to confirm
stab incidence.
Spacer Removed
-1
˚ Position
