63
5. Roll the supplied foam rubber to make a 4 layer
pad as shown. Make the pad slightly larger than
the ignition module.
6. Secure ignition module with nylon tie as neces-
sary.
7. Allow ignition pickup and power wire to pass
into the motor box as shown.
8. Mount ignition battery to motor box side using
foam pad and nylon tie as shown.
9. Mount switch in accordance with the switch
manufacturers instructions and hardware. We
elected to mount the switch inside the radio
compartment as shown below. The switch can be
easily accessed from the cockpit door. If this
switch position is used, allow plenty of room for
the door to close.
