61
16. If installing a choke servo use the provided
mounting tray and hardware shown below. Fol-
lowing same installation steps used for installing
throttle servo install choke servo.
17.
If a manual choke will be installed gather the
choke pushrod and ball link assembly as
shown.
18. We recommend installing the carburetor choke
pushrod as shown. Attach ball link to choke
arm as shown. Use the provided 4-40x300mm
pushrod to extend out of the cowling, once the
proper length has been found, cut off excess
pushrod and bend at 90 degrees for better grip.
Note:
Using a small piece of shrink tubing on the
end of the pushrod provides a finished/
professional look.
19. Location of manual choke pushrod shown
below. Use a rubber grommet
(Supplied)
to
prevent the cowl from chipping due to
vibration.
