29
4. Place the control horns over the predrilled
mounting holes.
5. Use a drop of thick CA glue on each screw as
shown. Ensure that T2.6 x 7mm Screws are used
for the rudder
Note:
CA glues have a fast drying time.
Remember to work quickly.
3. Thread brass coupler half way into ball link. As-
semble ball link to control horn.
Note:
There are two types of 4-40 couplers supplied,
two are for the throttle and choke pushrods
and four are for the pull pull system. The
couplers with the solid base are to be used for
the pull pull assembly.
Rudder Control Linkage
Installation
2. Gather the Rudder control linkage parts as
shown below.
Required Parts
◊
2 - 1x1650mm Pull-Pull cable
◊
4 - 4-40 ball link assemblies
◊
4 - 4-40 Bolts
◊
2 - Brass spacers
◊
2 - Flat washer
◊
4 - Lock nuts
◊
2 - Left control horns
◊
2 - Right control horns
◊
12 - T2-6 x 7mm Wood screws
◊
4 - 3.5x5mm Brass swage tubes
◊
4 - 4-40 Coupler with nuts for cable
Required Tools and Adhesives
◊
1 - 3/32” Ball Driver
◊
1 - Crimping tool
◊
1 - Wire Cutter
◊
1 - Phillips Screw Driver
◊
1 - 1oz Bottle Gap Filling CA Glue
