59
9. Assemble the ball link and servo arm as shown
below.
8. Thread a 4-40 ball link onto 4-40x300mm push-
rod as shown. Ball link should be threaded onto
pushrod approximately half way, this will allow
for slight adjustment during final throttle setup.
10. Place throttle servo arm onto throttle servo as
shown. Position the arm so it is parallel to the
servo case, and open the throttle arm of carbure-
tor in the center or half throttle position. Align
the pushrod with the solder coupler and mark its
location. The pushrod should go all the way into
the coupler after it has been cut.
11. Remove pushrod from throttle servo and cut
throttle pushrod to length.
