ADEMCO Vista-128B PLUS, Инструкция по установке и настройке

Страница: 19 / 138

Section 2 – Partitioning and Panel Linking
2-7
Multi-Partition Multi-Panel Mode
To perform a function in the Multi-Partition, Multi Panel mode, follow the steps below:
Step Action
1
Enter User Code (for users 001-050) + [#] + [88].
The keypad displays the following:
PANELnn 1 2 3 4 5 6 7 8
STATUS x x x x x x x x
where “nn” = panel ID number (01-08), “12345678” are the partition numbers and
“xxxxxxxx” is the status of each partition of that panel. Status indications include:
A = Armed Away S = Armed Stay M = Armed Maximum
I = Armed Instant R = Ready N = Not Ready
B = Bypassed/Ready
✴
= Alarm T = Trouble
F = Fire Alarm P = AC Power Failure L = Low System Battery
C = Comm Fail
NOTES: See table later in this section for priority of displays.
A “
•
” under a partition number indicates the user does NOT have
access to that partition.
2 The following functions can be performed:
Press [1] to attempt to disarm all partitions.
Press [2] to attempt to arm AWAY all partitions.
Press [3] to attempt to arm STAY all partitions.
Press [4] to attempt to arm MAXIMUM all partitions.
Press [7] to attempt to arm INSTANT all partitions.
Press [ ✴ ] to read the status of the next panel.
Press [#] key to read the status of the previous panel.
Press [0] to exit mode. After a few seconds, the keypad displays the status of the
original partition of the original panel for the keypad. Also, this mode will end in
approximately 120 seconds if no keys are pressed.
NOTES: When performing any of the arming commands, if there are faults in
any of the partitions, none of the partitions will arm. These faults must
be corrected or bypassed before attempting to arm.
When performing either a STAY or INSTANT arm command the
system always arm in mode 1.
The user cannot execute another panel linking mode. To execute
another panel linking mode or to access a different remote panel, the
user must first exit this mode (return to the original control panel).