ACS ACS-24UHF/Eagle, Руководство пользователя

Страница: 217 / 239

217

Allow to thoroughly cool before removing clear transfer tape.

If using a heat press to press the stones to a shirt:

Set the temperature to ~ 330
—350 degrees F (165 – 175 degrees C) and set the pressure to medium.

Press garment first for a flat dry surface.

Arrange pattern on shirt, carefully centering. Press for 10-12 seconds.

Peel cold, cover with Teflon sheet, and re-press another 10-12 seconds. Alternatively, flip the shirt
inside out and press from the back for 10-12 seconds.

Use a lower temperature if pressing on 50/50 cotton poly fabric. Use a higher temperature on denim or
tote bags.
Extra tips on Rhinestone Applications

If you are combining iron-on transfer with rhinestones, do not press the rhinestones onto the iron-on vinyl.
While it will appear to have worked well, the stones will fall off once the garment is laundered. When using
both, create a contour line around your iron-on pattern for the stones.

Pressing rhinestones to cardstock also works very well. If pressing onto the front of a greeting card, unfold
the card first.

After pressing and allowing to cool, use your fingernail or an old credit card/gift card to scrape the pattern to
see if any stones come loose. If so, replace those stones with new ones and press again.
10.07 Drawing with a Pen or Glue Pen

With the ACS-24UHF, you can draw with any pen, pencil, marker, or glue pen, that can be securely gripped
by the blade holder seat and not be dragging across the material. The optional
Zing Pen Holder can also be
used to hold thinner pens. The advantage of the Pen Holder is that the center of the pen will be positioned
the same as the blade on the ACS-24UHF Blade Holder, thus allowing you to draw with the pen and then
cut out a shape. The pen will draw in the correct relative positions to the cut:

If you do not own the Zing Pen Holder or you wish to use a pen which does not fit into the holder, then refer
to the following section:
Adjusting for Differences in Diameters of Tools and Blade Holders.

When the project involves both drawing and cutting, you will need to use WYSIWYG for the cut mode so
that the shapes will be aligned.

Always draw first and then cut. Turn off the Blade Offset for drawing because it is not needed and can give
undesired results. But then remember to turn it back on for the cut process.

Do not have the pen positioned too low in the blade holder seat or the tip of the pen could drag across the
paper when moving from one shape to the next.

Make sure your shapes will not be drawn where any of the pinch wheels travel over the material. Otherwise,
the ink or glue could smear. Position your material on the cutting mat accordingly.

The Sakura Quickie glue pens work well in the ACS-24UHF. They will fit into the Zing Pen Holder, as well as
directly into the blade holder seat (if alignment with cutting isn’t needed).
Outside cut circle is
aligned with pen
drawn circle
Outside cut circle is
NOT aligned with pen
drawn circle