ACS ACS-24UHF/Eagle, Руководство пользователя

Страница: 25 / 239

25

Go to
Cut Project With…>Cut Preview.

The cut preview will display the shapes that will be cut. Immediately invoking the function again will show
the “material” with the cut shapes removed. This is also sometimes called the negative:

The Cut with Klic-N-Kut Series window can be accessed in the following ways:

Click on the Cut Project With icon on the File Toolbar

Press Ctrl+Shift+C

Go to
Cut Project With…>Klic-N-Kut Series…

The following window will open:

The above diagram shows the relevant section numbers for each setting. The Start
button doesn’t need its
own section as it simply initiates the cut once you have decided upon the other options.

Select KNK Maxx from the drop down menu under Klic-N-Kut Model. Set the Baud Rate to match the baud
rate selected in Section 1.05 Step 4.

The movement within the Klic-N-Kut logo can be toggled on and off by left clicking on the logo.
2.03 Force

The cutting force (also called pressure) greatly affects the quality of the cut. If the force is too low, the
material cannot be cut. If the force is too high, you will get bad cutting (even incomplete cutting at times) and
tearing of the material. Use recommended starting forces for the material you are cutting, test before cutting,
and make adjustments in order to get a clean cut.
Blade Offset :
Section 2.06
Cut Type:
Section 2.07
Start: will initiate the
cutting of shapes sent to
cut window
Force Setting:
Section 2.03
Speed
Setting: Section
2.04
Multi-cut Setting:
Section 2.05
Serial Port and Test
Connection: Section 2.08
Laser Offset: Section 9.02
Resolution: Section 2.10
Select KNK
Model and set
Baud Rate
Shape as shown
on Virtual Mat Shape shown with first
click of
Cut Preview
Shape shown after second
click of
Cut Preview
Set these on the
Control Panel of
the ACS-24UHF