ABB FSPS-21, Руководство пользователя

Страница: 82 / 214

Status word contents
The table below shows the contents of the Status word for the ABB Drives communication
profile. The upper case boldface text refers to the states shown on page
83 .
STATE/Description Value Name Bit
READY TO SWITCH ON 1 RDY_ON 0
NOT READY TO SWITCH ON 0
READY TO OPERATE 1 RDY_RUN 1
OFF1 ACTIVE 0
OPERATION ENABLED 1 RDY_REF 2
OPERATION INHIBITED 0
FAULT 1 TRIPPED 3
No fault 0
OFF2 inactive 1 OFF_2_STA 4
OFF2 ACTIVE 0
OFF3 inactive 1 OFF_3_STA 5
OFF3 ACTIVE 0
SWITCH-ON INHIBITED 1 SWC_ON_ INHIB 6
– 0
Warning/Alarm 1 ALARM 7
No warning/alarm 0
OPERATION. Actual value equals reference (= is within tolerance
limits, i.e., in speed control, speed error is 10% max. of nominal
motor speed).
1 AT_SETPOINT 8
Actual value differs from reference (= is outside tolerance limits). 0
Drive control location: REMOTE (EXT1 or EXT2) 1 REMOTE 9
Drive control location: LOCAL 0
Actual frequency or speed equals or exceeds supervision limit
(set by drive parameter). Valid in both directions of rotation. 1 ABOVE_ LIMIT 10
Actual frequency or speed within supervision limit 0
External Control Location EXT2 selected. Note concerning
ACS880: This bit is effective only if the fieldbus interface is set
as the target for this signal by drive parameters. User bit 0 selec-
tion (06.33)
1 EXT_CTRL_ LOC 11
External Control Location EXT1 selected 0
External Run Enable signal received. 1 EXT_RUN_ ENABLE 12
Note concerning ACS880: This bit is effective only if the fieldbus
interface is set as the target for this signal by drive parameters.
User bit 1 selection (06.34)
No External Run Enable signal received 0
82 PROFINET IO – Communication profiles