Page
37
of
44
3DGence Material Management System | version 1 | 03.2022
Fig. 44 Screens demonstrating steps to start the recrystallisation process of printouts
Once the recrystallisation process is complete, the chamber will automatically cool down to a safe temperature and assume
the DONE status. To reset the chamber status to empty, press the chamber area.
To cancel the recrystallisation process, press on the chamber area during the process. After pressing the chamber area, confirm
your intention to cancel the process by pressing the ABORT button. To reset the chamber status to empty, press the chamber
area.
Fig. 45 Screens demonstrating the process of cancelling the recrystallisation of printouts
5.
REGENERATION PROCESS OF DESICCANT CARTRIDGES
The 3DGence Material Management System device features an active air drying system, using granules used for drying
thermoplastics in conventional industry (e.g. injection moulding, extrusion). Thanks to a special cartridge in the device
chamber, the air penetrating the material spools is dried and the collected water particles are stored in the desiccant cartridge.
In order to remove the stored water, a special cartridge regeneration cycle has been implemented, during which the cartridges
are heated to a high temperature and the evaporated water is discharged through a vent at the back of the device.
It is recommended that a regeneration cycle is carried out every 21 days to maintain the best performance of the print
preparation process. In case the device operates in an environment with high humidity or has been out of use for more than
14 days, it is recommended to carry out a cartridge regeneration cycle every 14 days.
