Page
32
of
44
3DGence Material Management System | version 1 | 03.2022
V OPERATION OF THE DEVICE
1.
FIRMWARE UPDATE
Due to continuous development, the device's Firmware is periodically updated. It is important that the Firmware is always
updated to the latest available version. To enable automatic Firmware updates for the device, you must have the option "on"
in the Network settings menu
→ 3DGence CLOUD → allow automatic updates.
If the automatic update option is enabled, the
new Firmware will be downloaded and automatically updated when the device is restarted. It is required that the MMS be
connected to the network.
If "off" is set to "
allow automatic updates
", automatic Firmware updates will not be possible.
2.
SWITCHING THE DEVICE ON AND OFF
2.1.
Activating the 3DGence Material Management System
1.
Set the main switch located on the back of the device to ON (in the case of the 4 or 6-chamber version, also set the switch
to ON the 3-chamber unit).
2.
Press the power button on the left side of the front panel.
3.
The device will start up and the touch screen will be activated. During start-up, the MMS will begin to prepare for
operation, the start-up screen will appear followed by the device home screen.
2.2.
Deactivating the 3DGence Material Management System
1.
Make sure that no processes are currently running on the device.
2.
Press the power button on the left side of the front panel.
3.
Confirm the message on the screen that you wish to switch off the device. If the message is not acknowledged, the device
will return to the main menu and will not be switched off.
4.
When the message is acknowledged, the device will automatically switch off.
Note:
once the power button has been selected, the power must not be disconnected before the unit has cooled down
and switched off.
Note:
this procedure only switches off the power supply to the electronics. To completely turn off the power to the
MMS, set the main switch to the OFF position.
