![background image](http://html1.mh-extra.com/html/3com/secpath-u200-cs/secpath-u200-cs_installation-manual_440781114.webp)
7-7
Installing and Removing a MIM Module
Installing a MIM Module
Follow these steps to install a MIM, taking the NSQ1GT2UA0 module for example:
Step1
Power off the UTM device.
Step2
Remove the blank panel from the intended interface module slot at the rear of the device. For how to
remove a blank panel, refer to “Removing a Blank Panel” on page 7-4.
Step3
Gently push the module into the slot along the guide rails.
Figure 7-14
Install a MIM module
Step4
Fasten the captive screws on the module with a flat-blade screwdriver.
Figure 7-15
Fix the MIM
Step5
Power on the device, and look at the status LED of the slot on the front panel. If the LED stays on after
the module completes initialization, the module is operating normally; if the LED goes off, the interface
module fails the self-test.
Removing a MIM Module
Follow these steps to remove a MIM module, taking the NSQ1GT2UA0 module for example:
Step1
Power off the device.
Step2
Loosen the captive screws on the MIM with a flat-head screwdriver at the rear of the device.
Содержание SECPATH U200-CS
Страница 64: ...5 9 Figure 5 7 Web interface for the U200 M ...