1-10
LEDs in the upper corners to indicate its status.
Table 1-10
Description of Ethernet interface LEDs
Status
Description
Off
No link is present.
LINK
On
A link is present.
Off
No data is being received or transmitted.
ACT
Blinking
Data is being received or transmitted.
2) Specifications
Table 1-11
Technical specifications of the Ethernet interfaces
Item
Description
Connector type
RJ-45
Interface type
Autosensing (Ethernet does not support MDI/MDIX autosensing when
working in the forced mode)
Frame format
Ethernet_II
Ethernet_SNAP
10 Mbps (autosensing)
Half-/full-duplex auto-negotiation
100 Mbps (autosensing)
Half-/full-duplex auto-negotiation
Rate and negotiation
mode
1000 Mbps (autosensing)
Full-duplex auto-negotiation
The media dependent interface (MDI) standard is typically used for the Ethernet interfaces of network
adaptors. The media dependent interface crossover (MDI-X) standard is typically used on hubs or LAN
switches.
3) RJ-45
connector
The 10/100/1000Base-T Ethernet interfaces of the U200 series use RJ-45 connectors and support
MDI/MDIX autosensing. Category-5 twisted pair cables are used for RJ-45 connectors. Figure 1-11
shows an RJ-45 connector.
Figure 1-11
RJ-45 connector
Содержание SECPATH U200-CS
Страница 64: ...5 9 Figure 5 7 Web interface for the U200 M ...