Prestige 310 Broadband Sharing Gateway
Network Address Translation (NAT)
6-7
Figure 6-4 Menu 11.3 — Applying NAT to the Remote Node
The following table describes the options for Network Address Translation.
Table 6-3 Applying NAT in Menus 4 and 11.3
FIELD
OPTIONS
DESCRIPTION
Full
Feature
When you select this option the SMT will use Address Mapping Set 1
(menu 15.1 - see
section 6.3.1
for further discussion). You can configure
any of the mapping types described in Table 6-2. Choose
Full Feature
if
you have multiple public WAN IP addresses for your Prestige.
None
NAT is disabled when you select this option.
Network
Address
Translation
SUA Only
When you select this option the SMT will use Address Mapping Set 255
(menu 15.1 - see section
6.3.1
). Choose
SUA Only
if you have just one
public WAN IP address for your Prestige.
6.3 NAT
Setup
Use the Address Mapping Sets menus and submenus to create the mapping table used to assign global
addresses to computers on the LAN. You can see two NAT Address Mapping sets in menu 15.1. You can
only configure
Set 1
.
Set 255
is used for SUA. When you select
Full Feature
in menu 4 or 11.3, the SMT
will use
Set 1
, which supports all mapping types as outlined in Table 6-2
.
When you select
SUA Only
, the
SMT will use the pre-configured
Set 255
(read only).
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Network Address Translation= SUA Only
Metric= N/A
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.
