ZyXEL Communications IES-2000, User Manual

Page: 86 / 304

IES-2000/3000 User’s Guide
6-6 System Commands
192.168.1.1 sys> syslog [<mode>]
where
<mode> =
enable
or
disable
.
This command enables or disables the sending of logs to your UNIX server. The default is disabled
(
<mode>
= disable). A log is sent if
<mode>= enable
. To display current settings, do not specify a
<mode>
.
6.6.2 Syslog Facility Command
Syntax:
192.168.1.1 sys> syslog facility <facility>
where
<facility> = Local1 to local7.
This command sets the syslog facility for the UNIX system.
6.6.3 Syslog Server Command
Syntax:
192.168.1.1 sys> syslog server <server IP>
where
<server IP> = IP address of syslog server.
This command sets the UNIX server IP address. If
<server IP>=0.0.0.0
(default), then logs will be
dropped (not be sent).
6.7 System Error Log Commands
The system error log will record error events locally to the line card’s memory. You may clear or display these
logs using the commands listed in this section.
The following lists what logs the system error log can record.
ADSL link on
(port number, sequence number,
rate, noise margin, attenuation)
ADSL link down
(port number, sequence number,
noise margin, attenuation)
ADSL OVER_HEAT_ACTIVE
(temperature)
ADSL OVER_HEAT_RELEASE
(temperature)
Console session begin Console session end
Telnet session begin Telnet session end
Incorrect telnet password
Insecure telnet access
(IP address)
FTP session begin FTP session end
Incorrect FTP password
Insecure FTP access
(IP address)
FTP image error (reason) FTP receive file OK (file name)