ZyXEL Communications IES-2000, User Manual

Page: 112 / 304

IES-2000/3000 User’s Guide
8-10 SLC1024 Specific Commands
<tx vpi> = The VPI setting of the G.SHDSL ports for use with a TX based
network.
<tx vci> = The VCI setting for the G.SHDSL ports for use with a TX based
network.
<rx vpi> = The VPI setting for the G.SHDSL ports for use with Rx based
networks.
<rx vpi> = The VCI setting for the G.SHDSL ports for use with Rx based
networks.
The
set pvcs
command allows you to configure a single PVC for all of the G.SHDSL ports at once.
The
<rx vpi>
and
<rx vci>
settings will be equal to those of
<tx vpi>
and
<tx vci>
if the rx
settings are not configured.
8.5.19 Show PVC Command
Syntax:
192.168.1.1 gshdsl> show pvc <port #>
where
<port #> =
A port number, from 1 to 24.
This command allows you to display the PVC parameters of an individual G.SHDSL port
8.5.20 Show PVCs Command
Syntax:
192.168.1.1 gshdsl> show pvcs
This command allows you to display the PVC parameters of all G.SHDSL ports.
8.5.21 Display All G.SHDSL Line Information
Syntax:
192.168.1.1 gshdsl> monitor [<start port> [<stop port>]]
where
<start port> =
The first port number in a range of ports for which you want to display
line information. 1 is used if you leave this blank.
<stop port> = The last port number in a range of ports for which you want to display
line information. 24 is used if you leave this blank.
This command displays all G.SHDSL line information. Information is updated every five seconds. Press any
key and then press [
ENTER ] to stop updating information. Use
monitor
without any port numbers to display
line information for every port.