ZyXEL Communications IES-2000, User Manual

Page: 150 / 304

IES-2000/3000 User’s Guide
14-4 Remote Management
access flush
This command revokes access by any and all manager stations.
14.3.4 SNMP Access List Command
Syntax:
access list
This command shows the allowed access.
14.4 SNMP Trap Configuration
The line card uses the SNMP trapping facility to proactively report unusual events to one or more trap servers. To
configure the trap parameters, use the
trap
commands in the SNMP subsystem. After configuring the SNMP trap
parameters, save the configuration to the nonvolatile memory with the
config save
command.
14.4.1 Supported Traps
The line card supports the following traps
♦
coldStart Trap (defined in RFC 1215) :
This trap is sent at system start-up.
♦
authenticationFailure Trap (defined in RFC 1215) :
This trap is sent if a request arrives with an invalid community string.
♦
linkUp Trap (defined in RFC 1215) :
This trap is sent when a DSL port is up.
♦
linkDown Trap (defined in RFC 1215) :
This trap is sent when a DSL port is down.
♦
overheat Trap (defined in ZYXEL-MIB) :
This trap is sent periodically when a line card is overheated.
♦
overheatOver Trap (defined in ZYXEL-MIB) :
This trap is sent when the line card is no longer overheated.
14.4.2 Trap Add Command
Syntax:
trap add <community> <IP addr>
where