ZyXEL Communications IES-2000, User Manual

Page: 38 / 304

IES-2000/3000 User’s Guide
2-4 Installation and Configuration with the EEC1020
2. 192.168.1.1 vlan1q> vlan enable
Step 11.
If you are using tagged VLAN with the VLC1012, then perform the procedure below to complete the
VLAN setup after you have configured all the line cards in the chassis.
•
Using a web browser, log in to a line card.
•
Click the
VLAN Setup
link to go to the
802.1Q VLAN Static Entry Setup
page.
•
Click
Index
1 to go to the
Edit 802.1Q VLAN Static Entry
page.
•
Clear the
Active
checkbox todeactivate the entry.
2.5 Configuration of ALC1024 and SLC1024
The following is a procedure for the essential configuration of both ALC1024 and SLC1024. It only lists the
critical parameters that must be set for the card to be operational; the unit should work fine with the rest of the
parameters taking the default values. The procedures for configuring the ALC1024 and the SLC1024 are the
same.
To configure a DSL port:
•
Use the
enable port
command (see the ALC1024 Specific Commands and SLC1024 Specific
Commands chapters) to activate the port.
•
Use the
profile
and
set port
commands (see the ALC1024 Specific Commands and SLC1024
Specific Commands chapters) to configure the DSL port.
If your network does not require tagged VLAN, the default port-based VLAN configuration (see the Port-Based
VLAN Commands seciton in the Bridge Commands chapter) should be sufficient for the vast majority of cases and
no modifications are necessary. The default port-based VLAN configuration allows traffic from a subscriber to go
to the uplink only; no communication between subscribers is possible.
For tagged VLAN, the process is more involved. The configuration of the uplink MUST be the last step in the
configuration procedure, because once you change the settings, you will not be able to connect to the line card
with your computer, which is without tagged VLAN capability. If you wish, you can configure the VLAN
associated with the DSL ports before the uplink ports, or you can do this over the network after the line card is put
into service. See the
Configuring the Tagged VLAN section in the IEEE 802.1Q Tagged VLAN Commands chapter
for instructions and an example.
2.6 Configuration of VLC1012
The following is a procedure for the essential configuration of the VLC1012. It only lists the critical parameters
that must be set for the VLC1012 to be operational; the unit should work fine with the rest of the parameters
taking the default values.
Procedure:
Step 1.
On the
Switch Setup
page: