ZyXEL Communications IES-2000, User Manual

Page: 262 / 304

IES-2000/3000 User’s Guide
28-6 Switch-Related Commands
Port-based VLANs are specific only to the switch on which they were created. The factory default port-based
VLAN settings for VLC1012 are summarized below.
•
Port 0 (the CPU management port) forms a VLAN with uplink ports and can use all Ethernet ports as the
uplink.
•
The VDSL ports cannot talk to each other.
•
Each VDSL port forms a VLAN with the Ethernet ports and vice-versa.
Tagged VLANs (IEEE 802.1Q)
Tagged VLAN uses an explicit tag (VLAN ID) in the MAC header to identify the VLAN membership of a frame
across bridges – they are not confined to the switch on which they were created. The VLANs can be created
statically by hand or dynamically through GVRP. The VLAN ID associates a frame with a specific VLAN and
provides the information that switches need to process the frame across the network. A tagged frame is four bytes
longer than an untagged frame and contains two bytes of TPID (Tag Protocol Identifier; residing within the
type/length field of the Ethernet frame) and two bytes of TCI (Tag Control Information; a tagged header starts
after the source address field of the Ethernet frame).
TPID has a defined value of 8100 (hex). The first three bits of the TCI define user priority (giving eight priority
levels). The CFI (Canonical Format Indicator) is a single-bit flag, always set to zero for Ethernet switches. The
remaining twelve bits define the VLAN ID, giving a possible maximum number of 4,096 (2
12
) VLANs.
Note that user priority and VLAN ID are independent of each other. A frame with VID (VLAN Identifier) of null
(0) is called a priority frame, meaning that only the priority level is significant and the default VID of the ingress
port is given as the VID of the frame.
Of the 4096 possible VIDs, a VID of 0 is used to identify priority frames and value 4095 (FFF) is reserved, so the
maximum possible VLAN configurations are 4,094.
Each port on the switch is capable of receiving tagged or untagged frames. You can configure a VLC1012 to
receive only tagged or all frames on a port-by-port basis. If it is set to tagged-only on a port, then only tagged
frames are allowed to enter from that port and untagged frames are dropped; if set to all, then both tagged and
untagged frames are allowed to enter the switch. The VLC1012 does not alter the VID of a frame if it is already
tagged; however, when an untagged frame enters the switch, it is assigned the default port VID (PVID) of the
ingress (incoming) port. Thus a frame always has a VID inside the switch, regardless of whether it is tagged or not
on the wire. The default PVID is 1 for all ports, but this can be changed.
The egress (outgoing) port(s) of a frame is determined on the combination of the destination MAC address and the
VID of the frame. For a unicast frame, the egress port based by the destination address must be a member of the
VID, also; otherwise, the frame is blocked. For a broadcast (or multicast without IGMP snooping) frame, it is
duplicated only on ports (except the ingress port itself) that are members of the VID, thus confining the broadcast
to a specific domain.
TPID
2 bytes
User Priority
3 bits
CFI
1 bit
VLAN ID
12 bits