ZyXEL Communications IES-2000, User Manual

Page: 107 / 304

IES-2000/3000 User’s Guide
SLC1024 Specific Commands 8-5
where
<port #> = The port number, from 1 to 24.
This command displays information about the line speed, state and the line rate parameter of a G.SHDSL port.
An example is shown next.
192.168.1.1 gshdsl> list port 6
Port=6 Speed(Cmax/Act)=2048/ 0Kbps Cmin=192 State=Disabled/Down
where
<Cmax> = Configured maximum line speed in Kbps. The maximum G.SHDSL line speed you
configured. For details about configuring this parameter see section
8.5.15.
<Act> = The actual G.SHDSL line speed in Kbps.
<Cmin> = This is the configured minimum line speed in Kbps for this port. The minimum
G.SHDSL line speed you configured.
<State> = Displays the state of an individual G.SHDSL port and the G.SHDSL line. If this
parameter is disabled, then the G.SHDSL port and line is forced down. If this
parameter is enabled, then the G.SHDSL port and line may be up or down. See next
for more details.
Table 8-2 List Port Command - <State> Parameter
STATE STATUS
Up Enabled
Down
Disabled Forced down
8.5.9 List Ports Command
Syntax:
192.168.1.1 gshdsl> list ports [<start port> [<stop port>]]
where
<start port> = The first port number in a range of ports for which you want to display
information. 1 is used if you leave this blank.
<stop port> =
The last port number in a range of ports for which you want to display
information. 24 is used if you leave this blank.
This command shows the configured minimum speeds (if applicable), maximum speeds and states of all
G.SHDSL ports.
8.5.10 Set Profile Command
Syntax:
192.168.1.1 gshdsl> set profile <name> <Cmax> [<Cmin>]
where