Chapter 63 Security
GS2220 Series User’s Guide
505
63.5 Configure SNMP Trap Group
The Switch sends traps to an SNMP manager when an event occurs. From the
SNMP
screen, click
Trap
Group
to view the screen as shown. Use the
Trap
Group
screen to specify the types of SNMP traps that
should be sent to each SNMP manager.
Figure 381
Security > Access Control > SNMP > Trap Group
Port
Enter the port number upon which the manager listens for SNMP traps.
Username
Enter the user name to be sent to the SNMP manager along with the SNMP v3 trap.
This user name must match an existing account on the Switch (configured in the
Security
>
Access Control
>
SNMP
>
User Information
screen).
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Table 269 Security > Access Control > SNMP > SNMP (continued)
LABEL
DESCRIPTION
Summary of Contents for GS2220-10
Page 23: ...23 PART I User s Guide...
Page 49: ...49 PART II Technical Reference...
