Chapter 43 Differentiated Services
GS2220 Series User’s Guide
368
Figure 279
IP Application > DiffServ
The following table describes the labels in this screen.
43.3 DSCP-to-IEEE 802.1p Priority Settings
You can configure the DSCP to IEEE 802.1p mapping to allow the Switch to prioritize all traffic based on
the incoming DSCP value according to the DiffServ to IEEE 802.1p mapping table.
The following table shows the default DSCP-to-IEEE 802.1p mapping.
43.3.1 Configuring DSCP Settings
To change the DSCP-IEEE 802.1p mapping click the
DSCP Setting
link in the
DiffServ
screen to display the
screen as shown next.
Table 186 IP Application > DiffServ
LABEL
DESCRIPTION
Active
Select this option to enable DiffServ on the Switch.
Port
This field displays the index number of a port on the Switch.
*
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set the
common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Active
Select
Active
to enable Diffserv on the port.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Table 187 Default DSCP-IEEE 802.1p Mapping
DSCP VALUE
0 – 7
8 – 15
16 – 23
24 – 31
32 – 39
40 – 47
48 – 55
56 – 63
IEEE 802.1p
0
1
2
3
4
5
6
7
Summary of Contents for GS2220-10
Page 23: ...23 PART I User s Guide...
Page 49: ...49 PART II Technical Reference...
