Chapter 17 Link Aggregation
GS2220 Series User’s Guide
191
17.3.1 Link Aggregation Control Protocol
Click
Advanced Application
>
Link Aggregation
>
Link Aggregation Setting
>
LACP
to display the screen
shown next. See
Dynamic Link Aggregation on page 187
for more information on dynamic link
aggregation.
Figure 150
Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
The following table describes the labels in this screen.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Table 79 Advanced Application > Link Aggregation > Link Aggregation Setting (continued)
LABEL
DESCRIPTION
Table 80 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL
DESCRIPTION
Link
Aggregation
Control
Protocol
Note: Do NOT configure this screen unless you want to enable dynamic link
aggregation.
Active
Select this check box to enable Link Aggregation Control Protocol (LACP).
System Priority
LACP system priority is a number between 1 and 65535. The switch with the lowest system priority
(and lowest port number if system priority is the same) becomes the LACP “server”. The LACP
“server” controls the operation of LACP setup. Enter a number to set the priority of an active port
using Link Aggregation Control Protocol (LACP). The smaller the number, the higher the priority
level.
Summary of Contents for GS2220-10
Page 23: ...23 PART I User s Guide...
Page 49: ...49 PART II Technical Reference...
